Digital Tensile Testing Controller

Power Supply:110/230VAC, 50 Hz or +5VDC

RS-232 interface: 3-wire

RS-485 interface: 2-wire or 4-wire

Galvanic Isolation of 1KV between RS-232 and RS-485/422signals

Supports high speed communication

Supports 32 nodes on RS-485 side

Enclosure: DIN rail mounting

Dimension:

Outer: 70 mm (W) x 60 mm (H) x 111 mm (D)

It is recommended to use twisted shielded pair of cablefor connecting on RS485 side

This device is very useful for inter connecting fieldinstruments, PLC, PC, HMI etc.

MICROCONTROLLER BASED

• Accepts Analog Input: 4.0-20.0mA, 0-20 ma, 0-5 V, 1-5 V
• Four Keys membrane Like Keypad
• 4-Digit Numeric 0.56 /0.8 Red LED display for Process Variable
• Operating at 100-263VAC
• Transmitter Power supply: +24VDC/50mA
• Programmable parameters: Zero, Full scale, Decimal position
• Non-volatile Memory for storing configuration parameters
• Calibration thro software

Options:

•  Retransmission: 4.0-20.0mA Isolated (Linear Proportional to Indication)
•  Two Relays (5A/230VAC) for Alarm
•   Communication: RS232 or RS-485 (2-wire), MODBUS protocol
• Mechanical Data: Mounting: Panel mounting
•  Cutout size: 92 mm x 44 mm
•  Outer dimension: 96 mm x 48 mm x 120 mm (Depth)
• Enclosure: Normal

MICROCONTROLLER BASED 

Input: Load cell 

Four Keys membrane Like Keypad 

Display: 16 Character 2 Line LCD with Green Back light

Operating Voltage : 230 VAC, 50 Hz +/-10%

Excitation Voltage: 5 VDC

Sampling rate : 

Programmable set points, with indicators and outputs

Peak readings always displayed

KG and KN selectable thro’ parameter

Password protection of calibration 

Field Calibration thro’ software

Accuracy: 

OPTIONS: 

- USB port to store testing data with PASS and FAIL result

MECHANICAL DATA: Panel mounting type Plastic enclosure

- Cutout size: 92 mm x 92 mm

- Outer dimension: 96 mm x 96 mm x 120 mm (Depth)